Medical/biohazardous waste generated at LBNL must be disposed of in biohazardous waste bags, as discussed in detail in the following section. Biohazardous waste bags must be placed in labeled biohazardous waste containers.
Biohazardous waste labels with either the words "Biohazardous Waste," or with a biohazard symbol and the word "Biohazard" (see Figure 2-1) must be placed on biohazardous waste containers.
Biohazardous waste bags must be either RED or clear (orange bags are not allowed) and labeled with either the words "Biohazardous Waste," or with a biohazard symbol and the word "Biohazard." These bags must be disposable and impervious to moisture, and have strength sufficient to preclude ripping, tearing, or bursting under normal conditions of usage and handling.
Red biohazard bags must be used for Medical Waste, which is regulated by the California Department of Health Services (DHS). Regulated Medical Waste is generated or produced as a result of any of the following:
diagnosis, treatment, or immunization of human beings or animals;
research pertaining to treatment, diagnosis, or immunization of human beings or animals;
or the production of biologicals.
In some cases, LBNL researchers generate biological material which is then transferred offsite for DHS regulated use. Incidental regulated use of the material offsite does not make the waste regulated at LBNL. Red bags are used to line all medical/biohazard containers in laboratories where any regulated medical waste is produced, and red bags are used to line all pickup containers provided by the disposal contractor. If a room uses red bags, the waste will be presumed to be regulated and must conform to the red-bag requirements listed after the flowchart.
Clear biohazard bags are used for biohazardous waste that is not regulated by the California Department of Health Services (DHS). The Waste Management Group must document that a laboratorys biohazardous waste is not regulated in order for a laboratory to use clear biohazard bags. Anytime that the research significantly changes in a laboratory that uses clear bags, it is the responsibility of the Principle Investigator to notify the Waste Management Group of the change (contact Charlotte Van Warmerdam at x7579 or your assigned WMG Generator Assistant).
The color of a biohazardous bag is used to differentiate between waste that is regulated by DHS (red) and waste that is not (clear). The color of the bag does not indicate the level of biological risk or final treatment. Both colors of bags are disposed and treated by LBNLs biohazardous/medical waste disposal subcontractor in the same manner.
flowchart (Figure 2-4) shows the basis for clear-bag use for solid
medical/biohazardous waste as well as disposal guidelines and definitions for
medical/biohazardous waste. Use this chart to determine if your laboratory
biohazardous/medical waste is regulated by DHS and must therefore be contained
in a red bag:
Clear Biohazard Bag Program:
All biohazard bags in the room must be part of the Clear Biohazard Bag Program.
Once a room switches to clear bags, the room must continue to use clear bags unless the research significantly changes.
Generators are responsible for supplying their own bags. The bags must be clear or white and labeled with the biohazard symbol or wording. The bags do not need to be certified for autoclave use. The following suppliers sell clear biohazard bags of various sizes:
Full bags must be tied or taped closed and disposed of in gray pickup containers lined with red bags. Fill out the Accumulation Log with the wording unregulated lab waste.
Lab containers may not be overfilled.
Containers must be labeled with the biohazard symbol or wording.
Dispose of clear bags when they are full or if there is a noxious odor. Weekly disposal is not necessary for clear bags.
Benchtop containers lined with clear bags do not need to be covered. Larger containers lined with clear bags should be covered as a best-management practice.
Sharps waste must continue to be accumulated in a sharps container labeled as unregulated sharps. These containers may not be overfilled.
Only those generators notified by Waste Management that they qualify may participate in the clear-bag program.
Generators must take EHS 730: Training for Medical/Biohazardous Waste Generators.
Red Biohazard Bag Waste:
All biohazard bags in the room must be part of the Red Biohazard Bag Program.
Generators are responsible for supplying their own bags. The bags must be red and labeled with the biohazard symbol or wording. The bags do not need to be certified for autoclave use. The following suppliers sell red bags of various sizes:
Full bags must be tied or taped closed and disposed of in gray pickup containers lined with red bags. Fill out the Accumulation Log with the type of waste.
Lab containers may not be overfilled.
Dispose of red biohazard bags at least once a week.
All containers, including benchtop containers, must be covered with a lid when not in use, and the lids must be cleaned once a week.
Containers, including benchtop containers, must be labeled with the biohazard symbol or wording.
Sharps waste must be accumulated in a sharps container labeled with the biohazard symbol or wording. These containers may not be overfilled.
Generators must take EHS 730, training for Medical/Biohazardous Waste Generators.
Biohazardous waste containers (Figure 2-5) must be rigid and leakproof, with a tight-fitting lid, and preferable a footpedal to operate the lid. The containers may be any color, but they must be labeled with either the words "Biohazardous Waste," or with a biohazard symbol and the word "Biohazard." The labels must be placed on both the lid and the sides of the container. The labels must be visible from all sides of the container. In addition, biological materials of human origin that are covered by the OSHA Bloodborne Pathogen Standard must be placed in containers that are red or containers that have fluorescent orange or orange-red biohazard labels.
Biohazardous waste containers must be lined with biohazardous waste bags before adding the waste. The labels on the container must be visible once a biohazardous waste bag is added. There are biosafety reasons and regulatory requirements for maintaining lids in place on containers. In general, lids should be used to prevent the spread of potentially infectious agents or material. The lid should be kept closed on the container whenever waste is not being actively added to the bag. At a minimum, the lid must be on the container during breaks, lunch, and at the end of each workday. Small countertop containers lined with clear bags (used for nonregulated biohazardous waste) can be used and kept uncovered. Larger containers lined with clear biohazard bags should be covered as a best-management practice.
Biohazardous waste containers need to be placed in the laboratories near the point of medical/biohazardous waste generation. Medical/biohazardous waste must be segregated and physically separated from other wastes. Avoid, if possible, mixing medical/biohazardous waste with chemical or radioactive materials.
Medical/biohazardous waste must be free from radioactive and chemical contamination to be classified and disposed of as medical waste.
The waste is collected from specified containers called pickup containers (Figure 2-6). The pickup containers are supplied by the LBNL medical/biohazardous waste subcontractor and are usually gray in color, except for red pathology containers, which are discussed later. They are prelabeled with biohazard symbols and the word "Biohazard." Medical/biohazardous waste collected in laboratory waste containers (red-bagged or clear-bagged) must be transferred to these pickup containers for pickup. Laboratory waste in red bags must be transferred weekly. Laboratory waste in clear bags need only be transferred when the bag is full, there is a noxious odor, or continued accumulation may present a biohazard to personnel.
There are designated pickup sites around the laboratory where medical waste is collected by LBNL's medical/biohazardous waste subcontractor.
Wear and use personal protective equipment (PPE) appropriately when handling medical/biohazardous waste (Figure 2-7). Wear PPE (e.g., lab coat, gloves, safety glasses) to prevent potential contact with and exposure to infectious material. In addition, prevent the spread of infectious material by: a) changing gloves that have been used or may be contaminated, b) not touching doorknobs or other clean surfaces with gloved hands, and c) washing hands after removing gloves.
Seal the biohazard bag closed (tape, rubber band, etc.). Carry the biohazard bag to the nearest medical waste pickup container (Figure 2-8). The biohazard bag must be secondarily contained during transport in a labeled biohazard container with a lid.
This is a necessary precaution, should the bag leak. Remove the biohazard bag and deposit it into the pickup container. The pickup container must be lined with a red biohazard bag. Close the lid on the pickup container after adding the waste.
Fill out the Medical Waste Accumulation Log which should be affixed to the lid of each gray pickup container.
Note: Do not overfill the gray pickup containers. The lid must be able to fully close. Start a new one if necessary. Wash your hands after removing your gloves.
The California Medical Waste Management Act prohibits accumulation of medical waste on site for more than seven days above 32F. Therefore, you must dispose of any waste in a red bag each week. Currently, pickups are on Wednesday mornings for hill locations and Thursday mornings for Potter St.
Laboratory biohazardous waste container lids are not protected by the red bag liners, and must be cleaned and disinfected whenever the bagged waste is removed from a container lined with a red bag. In practice, this means that the lid of the laboratory container should be wiped down on the inside and outside every time waste is transferred to the pickup container.
To clean the lids, use a freshly prepared 1% bleach solution containing 500 ppm available chlorine. Prepare the 500 ppm solution by adding 1-1/4 ounces (38 ml) of household bleach (with 5.25% sodium hypochlorite) to one gallon (3.78 liters) of water. Wipe the inside and outside of the lid with this solution.
Our medical/biohazardous waste subcontractor is responsible for replacing the gray biohazardous waste pickup containers with clean containers every pickup day. However, it is the generator's responsibility to disinfect the laboratory biohazardous waste containers periodically. At a minimum, these containers must be cleaned and disinfected any time a biohazardous-waste bag develops a leak, or if the container is visibly dirty. Each laboratory container should be cleaned not less than once each quarter.
To clean the barrels, use a freshly prepared 1% bleach solution containing 500 ppm available chlorine. Prepare the 500 ppm solution by adding 1-1/4 ounces (38 ml) of household bleach to one gallon (3.78 liters) of water. The minimum contact time for the bleach solution is 3 minutes.
Remember the waste must not be defined as chemically hazardous or radioactive before drain disposal or cause a violation of the LBNL wastewater permit discharge limits. Contact Environmental Services Group (x7327) for assistance with this type of waste.
Exception: Medical/biohazardous waste that contains only residual amounts of bleach, phenol, ammonia, iodoform, or permanganate solutions may be placed into the medical/biohazardous waste containers.